Anyone know the part number for a D10N cutting blade for on a semi U blade and the same for a D11R? thanks
You mean a cutting edge I assume ..? Normal edge or ARM protected..? Standard or extra thick for more wear material..?
As usual it's not simple ..... depends on the Serial Number prefix of the blade - located on a plate on the back side of the blade at the RH upper corner. Doesn't matter if the tractor is an N, R, or T, they all use the same type of blade so cutting edges will fit pretty much anything so long as they suit the Serial # prefix of the blade. 10SU blade .... 79W-prefix In each case the first Part Number is installed in the centre of the blade, the 2nd one on the outside before the end bits. 35mm thick edges - 2 x 1U-4499 & 2 x 1U-4455 40mm thick edges - 2 x 4T-0081 & 2 x 4T-0082 45mm thick edges - 2 x 6Y-0016 & 2 x 6Y-0017 50mm thick edges - 2 x 4T-0607 & 2 x 4T-0604 60mm thick edges - 2 x 6Y-0020 & 2 x 6Y-0021 All other 10SU blades - 1RH, 7RH, 4KP, 6EP, BHJ, BHA 35mm thick edges - 2 x 9W-6609 & 2 x 9W-6608 45mm thick edges - 2 x 9W-6656 & 2 x 9W-6657 60mm thick ARM-protected edges - 1 x 195-9170, 2 x 195-9171, 1 x 201-1230 11SU blade - all prefixes 45mm thick edges - 2 x 9W-2426 & 2 x 9W-2425 60mm thick edges - 2 x 9W-4495 & 2 x 9W-4494 75mm thick edges - 2 x 135-9577 & 2 x 135-9578