Mornin’ ya’ll. Been messing with this machine for a little bit now, and just replaced the quick attach hydraulic cylinder due to being able to move the cylinder easily by hand and the cylinder not staying in the lock position. At first I thought the cylinder was just the problem, but now it opens and only *attempts* to close. When you hit the switch, you can hear the hydraulics trying to do something but nothing happens. Any insight would be greatly appreciated!
sounds like the electric valve needs a look-see.
when you say the electric valve, are you talking about the valve assembly at the front of the machine or underneath the cab?
On a TL250, the valve is on the quick attach frame. Single spool with two coils (on top of each other). I can't find parts manual for yours.
I have a TL12v2 im working on im not getting any power to my switch in the cab is there a fuse or a relay somewhere im getting a ground on my center post to the switch or dose the switch work off ground? any help wpuld be greatly appreciated thanks.
working on one also same issue. mine is intermitent. not having a lot of luck. It is fuse 5 (15 amp) and there is a set of relays inside engine compartment . but there is a controller that makes the decision. not found its logic just yet.
After playing around I got mine to work, no power to the switch unless the Hose release switch is properly set. Look close at it where your hydraulics hook up.