Got a call to check this directional drill out. Unit would not turn over. Starter signal is not getting power, after digging around and looking at the schematics Ive found that the "ground" wire from the start relay passes through a diode which tees into the ground for the drill/drive enable relay which also goes through a diode then goes to a 2 second seat delay relay. If i jump the ground wire to ground i can get it to start but then it wont drive or drill. the seat switch is by passed and the harness looks good. the diode packs look good and the harness looks good. anyone have any experience with these, as i do believe im missing something stupid, or im just stupid. either way could use the help. 2000 ditch witch jt4020 #2v0684
No replies yet.