The tractor dont shift on 3 and 4 ...run on 1 and 2 gear ....i try to figure out the trouble and how to get the code on the dash display ...thnx appreciated
Look under the plate on your shift lever should be lights. far right light S or 8 is green it is your speed sensor with rpm sensor loss will only shift 1st and 2nd
What he said, speed sensor.
I dont have those light ...i think i got the series 2 .....
Is yours a power shift or do you have a manual four speed trans
Power shift ....but i only have a screen that show the mph on dash no other lights
What does your shifter look like most of it may be under a plate. any thing like this?
No ....just a normal shifter that u turn for gear 1 to 4 ....look to be the speed sensor ...anyone find a better deal than 900$ for the sensor ???
are you using part# 380004a1 believe this to be the correct part# but not sure Shows about $400.00 on net
Us or canadian ?? Im in canada....yes thats the correct parts number
Try this have worked with them before with good luck. check with Tammy about price to Canada ( [email protected] ) 612-284-9300 ex 9001
380004A1 , 87611747 , 8100228 , 85817029 Anyone can tell me if all those parts number are the same sensor ...it seem they are the same but start at 200$ to 900$
Yes they all relate to the same part, you have a mix of CNH & New Holland numbers. (Not sure on 8100228) CNH 380004A1 now subs to 87611747 NH 85817029 now subs to 87611747 Originally you could purchase just the speed sensor & you would have to fit it to the original wiring input plug for the control valve. Just guessing, but now you probably purchase the complete control valve loom, including the speed sensor main input plug & connectors for all control solenoids. Hence the big price difference........
Suplier sell the sensor for 138$ but u need to buy the sensor from a dealer at 800$ thats really sucks
Look up your part number on ebay or amazon and go from there
Anyone got a picture how the sensor look??
Anyone know where i can get the wiring diagram for speed sensor ?? Just wanna make sure i doesnt have a broken wired
Get on line and either use bing or google there is some good info out there, you can even try youtube. But you might try your local dealer they may give you the info you need.
Item 41 is the sensor & the pic is of it in the valve - with valve removed. If you look VERY closely at the pins at the plug at the control valve (X35) - each pin has an identifying letter next to it. This is what each pin controls.
Here is the schematic for a 580SM ser 1 - I don't have anything later 130 is the plug at the control valve 129 is the plug at the control module I hope this is of some help