I just bought this dozer 1 wk. ago. Was doing fine for about an hour. Right track brake started glitching, jerking like trying to steer right. Then the dozer would stop, and the trans yellow light would come on. Sit about 1 minute the light would go off and everything back to normal for about 5 minutes and then do it again. Pulled the joystick can cleaned the connections and now it won't move. Dash shows N when can is unplugged and when you plug the can in goes to flashing F with trans light on and park light on. Will not move. When I scan through the menu the only thing it says is N5-NONE. The percentage buttons will work up and down. Have cleaned fuse panel and replaced all fuses and cleaned and checked all the relays and their panels. And they were all nasty. Cleaned all battery post and cable ends, bypassed the kill switch because it was crusty and hard to turn. Just bolted all the grounds together. Took the positive post off the batteries overnight with no luck. I have been reading on here and trying to figure things out but have had no success. New joystick is 3200.00!!! Can you buy parts just for the joystick?? What's my next move?? Thanks.
No replies yet.