First off I’m losing brake fluid on the right side. New master cylinder and slave cylinder. No leaks can be found anywhere. I’m assuming there’s an internal leak in the brake control valve body somewhere? Any idea how hard that is to fix? 2nd: I took off left and right brake clutch housings and replaced gaskets and o-rings on the shafts. The left side sealed great. The o-rings on the right side shaft are still oozing fluid. I ordered case specific o-rings but I wasn’t happy with the fitment. They seemed too narrow for the groove. Has anyone used common o-rings out of a generic kit and had luck? The shaft isn’t tight enough to seal, it has a very small amount of wiggle, so I figured it would still leak. Needs a fatter o-ring. Housing bore looked great. Other than that it’s a great machine
No replies yet.