Heavy Equipment Forums Heavy Equipment Community

Case CX135

dbf577 ยท 2008-03-07 18:29

i just bought a new case cx 135 and was wonder if anyone knew where the pattern changer was on it. Thanks

Replies6
  1. #1Countryboy2008-03-07 19:08

    Welcome to Heavy Equipment Forums dbf577! :drinkup

  2. #2CM19952008-03-07 20:30

    The location of the pattern changer should be in the operations manual - or just call your salesman.

  3. #3dbf5772008-03-07 20:59

    Thanks i looked in owner manuel ill look again

  4. #4Deereman2008-03-07 21:22

    Patter Change Did it com equiped with it? If so it should be located behind the cab door on the first access pannel in the floor of it. I could be wrong but don't think that anyone offers it in the cab besides the mini-ex's.I've seen aftermarkets.Or possibilly on the first right side big panel. I believe its where the control valve is located. But if it does not have you will have to more then likely cross out or swap out four lines in an x-pattern. It should be in the manual. If not you better call the dealer and ask b/c if you go and start talking off hoses and not mark them and put them back on you will get SAE/ISO ****** up controls:nono. When you do start just take some colored wire and wrap around each one to know which is which. :thumbsup

  5. #5CM19952008-03-08 08:52

    The Cat 321CLCR's have the pattern changer in the floor right by the door under a piece of rubber floor mat, it was really in a bad place because dirt and small rocks would work there way into the set screw holes. :Banghead dbf577 here is a link that may help http://www.mycasece.com/pages/login.asp

  6. #6dbf5772008-03-09 17:16

    thanks for all the replys i found it under the floor mat.