Hello everyone, I have a question about a machine that i recently bought. It is an Case CX210 LC construction year 2005. The machine has worked perfectly but since a week or so it keeps asking for a password. The machine now only runs stationary (so i can not use it to work with) and on the display panel it only shows "password" and four blank spaces. We also tried to start the machine with the same motorcontroller from an other machine also a Case. That worked for some days, so the machine was running fine again and doing all it should do but since today with the replaced motorcontroller, it again asks for a password and the machine now only runs station as it did before. Does anyone have experience with this kind of problem? I contacted the previous owner of the machine but heard nothing yet so i thought let me try it on here. Thanks in advance.
Your anti-theft system is activated. Disconnect the wires at connector x9, (wires are Violet 469 and Black 621 ) This should disable your anit-theft. The wires are behind the seat, under the cover, near the relays. If you want the anti theft off, just leave the wires disconnected. If you want to install a new code, disconnect the wires, turn the key on then off. Re-connect the wires. Key on, and password should display. Enter in new code, travel switch changes the digit, work switch changes to next digit. Auto button confirms the code and enters it into the system.
Thank you so much for your help!! It worked.
Spanner light code on the screen CX210B Case Crawler Excavator how can I reset it model 2014
Please start a new thread next time. If you need further help, start a new thread. Thx. HeavyEquipmentForums If you need to reset the maintenance timer, push and hold the horn volume button for more than ten seconds.
weel excavator Pls i need the password for erases fault code for case weel excavator wx series Thanks
I heve the manual &can not find any diagram for wire & connector.I do not see any voilet wire near the relay
Is this the same for 130c model case same problem
This post just saved my skin. Value of this forum.......priceless!
hello guys, does anyone know the service code for the case wx210 calibration, the machine is 2005