my case sv 185 burn crank fuse when i put start putton. has somebody same problem. what should i have to do with that sorry bad english.
Im assuming its EH controls? Its the 15amp fuse? Usually the right joystick wires have broken. Unplug the joystick connector, and see if the fuse still pops(its behind the seat, and you have to take out the back cover, just remove all the clips)
25amp fuse i have take out bought jouystick connectors and fuse still pops when i press start button
Need more information now. Is it tier 3, or tier 4? Tier 4 machines will have steel lines going to the exhaust, and your cluster will ask you to regen as needed.
it is tier3 year model 2012
K. One more thing, the crank fuse only blows when you push the start button, or as soon as you power on the display?
yes crank fuse only blows then i push the start button
You have the ISM engine? From sheet 4, F003 25amp crank fuse to wire 626 white. to sheet 10 to connector x52a / x52b to wire 626 white to pin 10 engine configurator, to Sheet 13 Starter ring terminal wire 627 white I would start by unplugging the ring terminal at the starter, and see if the fuse still blows. If it does, then you will have to follow the wire back and check for rubs in the harness. If it stops blowing the fuse, then your starter has failed. If you need to raise the loader arms to get to the starter, key on and hold the ride control and float buttons, and use another machine to lift the loader. ***If the fuse still blows with the starter terminal unplugged**** 1. Most of the harness issues will be in the connectors. They are prone to getting water in them, and corroding. Most of the harness rub points are near the connectors also. There is usually no need to cut open the loom in the harness.
Thank you very much i try to next raise loader arms but it happens next weekend when i get tracktor to my place. i write then what going on.
passing between the skid plate and engine wiring harness with the management number 627 runs were frayed bark broken. the driver's left-hand side where the wiring harness connector is located on the faceplate of about 10cm too short. Now the machine works. thank you very much for your information was very helpful.
Good to hear you found it. Thanks for the update.
Ilooked for a thread to answer, this seems to be the wrong one but thought someone may have an idea, I'm looking for the fuse box in a 2017 case sv185, it killed while running, I've been trying for hours to get it started, I have no glow plug light coming on at all, any ideas where to start?