Have blown a hose (unsure yet to do oil fill test) looses the tank oil into the belly in about 10 seconds oil every where hence unable to move locked up want to know how to release the brakes so I can skull drag it onto the loader either I get pine round logs under track so at least roll it up on to the tray think it is the left track hose that is gone have pressure washed it down will fill with another 30 liter oil start up low revs and hope to see leak location but if is this hose MUST get it on truck to get back to workshop as location now is on footpath Any TV380 Case machanics on here have hunted the net nothing
Probably not. If it is losing that much oil at just start up then you have lost a primary hose that moves oil with engine movement. It would pay to get the cab raised and take a look, it may be very obvious.
Yes cab raised pressure washed as belly holes where blocked after hole cleaned 30 gallon oil on ground today add oil start and watch for big spray of oil Guessing is the hose for left track as not turning May have to lift to loader with vrane back to workshop Will let you all know what hose went
Found leak hose to left track drive Using excavator to lift then lower the bucket to lift and then lower cab after cracking hydraulic hoses to release pressure now have bucket down and cab closed next organise crane to load on to low loader back to workshop left track remove to get to hose fitting replace then oil refill test run if success back to work
Good day. I have many Workshop for Komatsu Hitachi Case New Holland Terex and other [email protected]
The end came off hose the machine used to crimp fitting must faulty as the friend that worked on it had a truck in for new motor and found hose made by same company loosing the end of the hose He had a new one made Read my new post re machine goes stops goes stops operating GGGRRRRR
Sent you email check out my second problem on here re intermitent stop start