Have a 924f that will not go forwards or reverse. Everything else fuctions properly. I did some work to brakes and of 4 wires going into the brake pedal box, somehow 3 got pulled off and i (think) that is my problem. Not sure all what those two micro switches do. i dont have a clue what wires go where looks like some wire are tied together??. could somebody give me diagram from pigtail deutsch connector. #5,6,7,8 are the numbers being used. thanks so much for any help!
Had a Cat IT 24 that had a similar problem of not wanting to go into forward or reverse, and electrical warning light was illuminated. Problem ended up being a broken wire under the sheathing near the alternator. (which had been recently replaced) Took a while to find it. Good Luck DK25
hi ,go to right side of machine ,behind the ladder you will find the service connector, a fault light, a harness plug and the transmission ECM 1/CAN NOT help properly with out serial number 2/check to see if fault light is lit 3/unplug harness connector faults will parade through as a 2 digit flash code with a about 3 to 4 second delay between next fault record and get back Mark