I put new trans pump on, the other one was leaking now when i start it and put it in first or reverse have to wait for a half minute then it will move but have to rev it up tho seems like it pushes good,torque runs about quarter on the gauge when working it motor temp a little over half, leave it running no problem but shut it off for a bit it does it again always was a bit slow before but seems a little worse now any ideas thanks
I'd be looking for a leak on the suction side with those symptoms. Did you replace all the seals/gaskets, etc, on the lines right the way from the transmission oil pan when you replaced the pump..? It's a bit difficult to be more specific without a Serial Number.
yes the two rubber o rings that go on the pump hoses and one on the filter screen #4x3499 thank oyu
My first thought was also a suction leak. Loose clamp on a hose coupling or not positioned right, oring that fell out of place while fighting line into position and so on. If it was a leak on the pressure side it would be easy to find by the oil spraying out! Only other problem would be if there was a problem in the pump itself, but seems like if that was the case it would be worse when warmed up.
I will check the clamp tomorrow and post thank you
Did you put new suction hoses on? What was the condition of the old? Dry and crusty? Moving things around cracked the old. It sounds like its loosing prime. Put a pressure gauge on top of the filter housing, should be 300-350. Pop the floor plate and take a peek at the driveshaft after startup
checked this morning the suction hose from screen filter had regular hose clamp so put industrial clamp on seems good now thanks for all the replies