Heavy Equipment Forums Heavy Equipment Community

D6K fault codes list

CatD6k · 2024-07-04 07:45

Does anyone have a fault codes list for a Cat D6k2?

Replies8
  1. #1Nige2024-07-04 08:38

    Thereisn't really a single list as such. Each ECM has a list of Codes that are associated with it. Post up a Serial Number and a list of Active Codes/Events that you have.

  2. #2ahart2024-07-04 08:39

    I’d say there are roughly 1000+ potential codes, what are you looking for specifically

  3. #3CatD6k2024-07-04 08:41

    Serial serial WMR01029 and the codes are 2686-08 and E583-1

  4. #4Nige2024-07-04 08:55

    2686-08 is the left drive motor speed sensor, abnormal frequency, pulse width, or period. Test procedure attached. E583-1 is air filter restriction. The plugged air filter light on the panel should also be illuminated. Check the condition of the filters and replace as required.

  5. #5CatD6k2024-07-04 09:06

    Thank you for helping me! I am going to check this now.

  6. #6CatD6k2024-07-04 09:23

    Also just threw a 2685-02

  7. #7Nige2024-07-04 09:33

    That's on the same troubleshooting list as the 2686-08

  8. #8Nige2024-07-04 12:17

    Note the following from the troubleshooting procedure and check it first. Note: Prior to beginning this procedure, inspect the harness connectors that are involved in this circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure, and in good condition . If a problem with a connection is found, correct the problem and verify that the diagnostic code is active before performing a troubleshooting procedure. For sensors powered via the fuse panel, check the condition of the appropriate fuse before beginning the troubleshooting procedure.