Ive pulled the rams off my old drmco to put new seals in the rams, ive got the blade on the ground so it hasnt been moved at all since pulling them off, but how do i go about reinstalling them and 'bleeding' the air out of them and getting them to operate properly without damaging the crank arms? Hope ive explained myself well enough there.....
Hi, check this thread out it might be of some help to you. Cheers.
Thanks HSV127 that was very informative, when we put the rams back on we connected the rear of the rams up to frame, extended them using the hydraulics, then loosened the hyd fittings onto the rams and pushed the rods back in until they were in the right spot to reinstall the front of the ram to the crank arm, tightened them up and lifted the blade up and tried it and it all seems to work, we made sure we didn't move the blade while the rams were off whether that actually helped or not I don't know.