We have error code 36 on the controller, boom has no funtion. Manual said boom and offset parameter problem, how do i fix this problem. Book said red wire harness has wires to clear code but no red harness by back of controls.
It's actually Defective arm and offset potentiometer system. Boom Raise, arm In, and left offset cannot be operated. Check your wiring harness make sure there are no short circuit or disconnections.
Their may be a override switch under the seat at the front.. That will allow you to get everything on the ground to safety work on it. 9/10 times the potentiometers go bad then one would simply put a 60 ohm resistor in it place and all will work but you will have no setable offsets or safety's, the 60ohm resistor is the same as the work equipment being straight or centre position.