Park brake releases fine but brake light stays on
Welcome to HEF SCRD ! How about a machine serial number? That would be a monitor failure usually caused by one of the solenoids (PB, pedal lock, port lock) having a resistance too low allowing too much current to pass through the monitor. Measure the resistance of those solenoids and report back with the results. PB solenoid should be at the hydraulic filter head. The other solenoids should all be on the control valve under your feet, except maybe the port lock (that depends on the serial number of the machine).
KVO240A340027
With your serial number you should just have the 2 pedal lock solenoids and the PB solenoid. Report back with the resistance readings of those 3.
From what i see parts for this serial # show a park brake solenoid and lock out solenoid. No port or pedal solenoid. Can you send picture of pedal lock solenoids location? Will try to get resistance readings this week end and let you know.
Yes, PB and 2 lockout solenoids that lock your pedals. PB solenoid should be approximately 10 ohms. Lockout Solenoids should be approximately 16 ohms.
PB is .012 left pedal lock is .015 right pedal lock is .015
What scale is your meter set to?
I had it wrong . pb is 9.6 left pl 19.9 right pl 16.0
sorry left pl 15.9