Any advise on rebuilding a hydraukic cylinder on my 310C backhoe? I have an old :usaone I tore down and don't look like it would be hard. Would like any points though.
which cylinder and what gland does it have on it? Do you mean you already tore down a similar cylinder or your backhoe? If you have big enough sockets/breaker bar/cheater pipe and can make up a gland wrench they're not bad.
Delmer I did tackle it and the hard part was getting nut off the rod. It was very tight and did need cheater bar, although I got it and did the rebuild. Don't think I will be paying to do another since it worked out well> Thanks