Have a 2014 john deere 319E that stops when loading the bucket and only turns about 25degrees and stops, not the engine the drive.
Have a 2014 john deere 319E that stops when loading the bucket and only turns about 25degrees and stops, not the engine the drive. does anyone have any ideaswhat could be causing this ? Replaced charge pump, 2 new track sensors ??????
Welcome to HEF Jerry ! Need a machine serial number. Travel stops? Loader still work? Codes?
2014 year model 1TO3019EJEEJ267181 Loader still works good, when the machine meets resistenance it seems it stops as if you moved the direction lever to nuetral. The turning seems to be it just want turn but about 22 degrees and stops ??? I'll have to get the codes tomorrow. some showing are" EMU523693.4 EMU523694.12 EMU523694.04
All these are for auxiliaries. Will not cause your issue. Will wait to see if there are any other codes.
`The codes i listed are all that show up in Active Codes
Stored codes? Both sides stop? Oil level correct? Next would be a charge pressure check, in neutral @ fast idle and when the drive quits.
Stored Codes 1/6 Aux Hydraulic Ovr Rd 2/6 Exhaust Filter 3/6 Codes 4/6 Monitor 5/6JobTimer 6/6 Auto Idle Both sides stop when engaging bucket to ground, Oil Full, New Oil, New Hyd Filter (John Deere filter and Oil) RPM2700 575 lbs pressure when trying to turn drops to 300 or so
What is code 3/6? Be specific with numbers, not descriptions. Dropping almost 300 psi is too much. If you try and turn with one lever, then the other, one at a time, do both sides individually drop pressure to 300? I find it odd that you lose both sides. When it stops, does it sound like it is trying (going over relief), or does it just quit? Did you cut open the old filter to see what was inside?
The 1/6 etc codes are how they display in the monitor, 1/6 etc is 1 out of 6 codes the 3/6 is 3 out of 6 and shows Codes as description displayed in monitor. This machine does not have levers has Joystick , electric over hydraulic controls. It stopsjust like if you moved yoystick to nuetral neithe track trys to pull when trying to loading bucket. We did not cut open filter the oil was real milky with some trash in canister. Changed oil no milky (water) after changing no trash in canister after changing .
From this statement, you have problems. Not that it matters now after seeing the above post, but to get the codes by number, press and hold the menu button until service menu appears in the screen. Then scroll to codes. When it says 1 of 6, press select. You will get the SPN/FMI code. Press next after that to get the next code and press select, etc.