Hi everyone i have a s130 newer version of a 753 and ive been having trouble with my traction control it locks up sometimes and sometimes it works perfect i changed the brake solenoid and it wasnt that!! I tested my solenoid directly to the battery and it works, it has three wires coming out of it 1.ground 2.pull 3.hold the solenoid works everyway directly to the battery but i tested the pins on the connector that plugs into the solenoid and i have power on the hold pin but there is no power on the pull pin the wire has the number 4100 on it, i also tested the wire behind the connector and it has power also so theres a loose connection or something, anyone with any ideas or advice i would greatly appreciate it thanks....Matt
Check the seat safety switch, there was a thread here about the same problem, it's very commom in the 753/S130's.
Yeah ive read on that a little bit, but mine doesnt have that switch!! Thanks for the advice though
make sure you put the solenoid in correctly it only does in one way and tilts backward i believe look at the brake wedge and make sure the bolt on the bottom is not bent that will cause it to hang up and not work right either i work for bobcat and see that alot