Good night everyone. I have a 2023 xcmg xe35u mini(4ton) excavator. Which has 1way aux hydraulics. I want to run a hydraulic thumb on the machine. My question is is there any way of converting one way aux to 2 way aux? Also another question is it possible to change bucket and linkage bushings and pins from 35mm to 40mm? My machine has 35mm pins and I'm finding it hard to find quick hitches to fit it. The stick gap is 144mm, c-to-c is 195mm pin is 35mm. Even hard to find manual quick hitch for it. I'm entertaining the idea of making my own QH if I can't find a 35mm pin qh or if I can't fit 40mm bush and pins in. I also have a pic of the hydraulic schematics if that helps anyone to answering my original question to the converting from 1 way to 2way aux. Any and all help is appreciated. Hydraulic schematics picture attached below.
No replies yet.